How to Properly Adjust Your Bindings

[eternalblaze]

Ok so it seems simple enough to adjust your bindings to the boot. But does anyone have any tips when it comes to adjusting the bindings properly?

I read one of the threads and someone said to re-adjust them after two runs because the screws could have loosen due to the cold temp.

[Greco]

not re-adjust just check and make sure all your screws are tight after your bindings get really cold because they could loosen up due to the cold.

as for properly setting up non release bindings your goal is to have the center mark on the bottom of your boots line up with the center of the binding and the front clamp take a bit of force or effort to close and the boot not be loose at all. if you do all that you're set up properly.

g

[eternalblaze]

Thanks for the info.

[hamradio]

Yes, thank you. I didn't even know there were middle lines until I saw what you said, and then I got out the screwdriver. :D