What Do I do with this 4x4 square?

[CAN]

Hi everyone,
I bought these bindings from Manlenuim and they are great. What I do not know is how I use the small black plates that came with the bindings that have the 4x 4 holes in them. Is it some sort of spacer or washer. The spruce risers do not have any of these so I am clueless. Thanks in advance for any answers.
2093

[slow]

My guess is that it is a spacer to raise the riser off the skiboard to maximize board flex.

[rgzip]

My guess is that it is a spacer to raise the riser off the skiboard to maximize board flex.

That is correct. It goes between the board and the riser. I used to use that same setup, in fact those may be the same ones (I drilled them for 4X10)

[CAN]

Thanks Slow and RGzip. RG you think this is the exact set? They look great. I want to try them with the Condors in Utah.
Chad

[rgzip]

Thanks Slow and RGzip. RG you think this is the exact set? They look great. I want to try them with the Condors in Utah.
Chad

I think they are. Here is a picture of mine before I drilled them out.

FYI. With just the little plate spacer these had a little to much flex for me so I added a couple of rubber spacers ( bicycle innertube) which allowed me to adjust the flex as I wanted.

[valmorel]

Seems like you are upgrading EVERYTHING Can :)

[CAN]

Hey Dave,
Just trying to make sure I can stay on top of the snow. Also I am a sucker for a bargain whether I need it or not.

[slow]

Seems like you are upgrading EVERYTHING Can :)

CAN, your signature seems out of date. :D

[CAN]

Hi Slow,

Wasn't going to change it until they are in my hands,but if it bothers you, here you go.:D