Activity Stream

Nice chance to try my soft boot set up on the rear inserts of the Blunt Xl in unconsolidated junky snow at Sierra at Tahoe resort. . I think this...

Are these still for sale?

One day in last week.

My Ospreys arrived today!

With direct mounted release bindings https://www.ebay.co.uk/itm/143045680743

With direct -mounted release bindings. https://www.ebay.co.uk/itm/273597391775

Lucky you with that powder. I'm have had 3 days over two weekends. Sent from my SM-N910C using Tapatalk

Three runs and you'll have the hang of them. Sent from my SM-N910C using Tapatalk

We’ve been skiing in AZ since Thanksgiving, so I’m about eight days in. We had a couple of October storms that helped lay down some coverage and they...

I don't know. I asked Jeff to order and pre-cut me a pair. Have a look at climbingskinsdirect.com, because that is where he sourced them from. ...

How wide were your skins before you trimmed them? Sent from my SM-G955U using Tapatalk

The warm season continues and the snow conditions are even worse now. The resorts are doing their best to at least the blue runs open. I put the...

Thanks funmachine ... I’ve put in an email to Jeff to get some help on this as skis arriving Tuesday and need a solution by 28th as my only ski...

Me too Sent from my Moto G (5S) Plus using Tapatalk

I'd be game if the timing works out.

Thanks everyone. I ordered those sale crossbows and they're here already! Not bad for free shipping. Now if only the local resorts would open. Would...

Prices reduced Sent from my iPhone using Tapatalk

I keep a stubby 4" multi-bit ratcheting driver in my jacket pocket. In the handle is a #3, hex bits for my Bombers and boots, and a longer flat bit...

Thanks for the replies on this. She has decided to go with Stickies instead of the SnowJam boards.

You'd think Mac or Snap-on would make such a thing, but apparently no one in the world makes a stubby #3 phillips driver. Using a common #2 phillips...

I don't want to discourage you but Bad Wolf is right. Trying to mount Spruce risers to skis takes precision, effort, know-how, and the right tools. ...

I’ll contact Jeff as well for the dyna plate solution as that is a tried and tested solution Sent from my iPhone using Tapatalk

Thank you and understand ....Maybe this purchase was a bad decision. Been wanting a slightly longer ski for a while but maybe this is the wrong ski...

From personal experience, retrofitting snowboard inserts into skis or skiboards requires a high level of skill and equipment. A few of us on the...

The 141cm Ethan Too will only work with junior bindings and the shorter screws, or with Jeff's Dyna-Plate approach with adult bindings. The 151cm and...

Thank you Fun Machine for you thoughts on this and particularly the technical issue of using 9mm screws with adult bindings. Mine are the 141cm...

I think "best" depends on your personal preference. If you want to mount Spruce risers, then you need to install T-nuts from the base of the skis. ...

Hey, is Kimberly opening this weekend? The Horse is scheduled to open (it will be limited terrain, getting back to the village will require...